What we have now is a half scale model made out of foam core, screws, and wooden dowels, and it is not fabricated. The models of the furniture was all done on sketchup and printed by the laser cutter. What we would like to have for a final product is a full scale face hugger chair made out of compression spring locking devices and the new wooden parts. That is also fabricated. This would allow for a more sturdy chair, and for it to be held in more positions such as a bed, rocking chair, sofa, etc. We have an ok half scale model that could be slightly improved but is still functional. Graeme wanted something that could be a sofa, chair, and a bed but also only made out of one piece that could act as a joint as well. I wanted a clear plastic chair with water in it and LEDS in the bottom for a light show effect. What we thought the project would turn out to be would be a clear plastic sofa with water in it that folded out into a bed and chair, being supported my six spider legs but we have gone through many iterations since then.