Our project, Cylindero, is a radio controlled vehicle with lights, and is capable of driving at fairly high speeds. Now completed, the interior electronic components of Cylindero are no longer visible. Cylindero is constructed of 3d printed plastic components, most of which were designed in the early stages by us. Our concept has changed since the beginning, for practicality and structural reasons, but it is very close to what we originally planned, and for that we are proud. We did, however, face design challengs which we were forced to overcome. For one, a base problem of Cylindero is its main design. For it to work, the motors must be the centerpiece, not the arduino or battery. The whole construct would have to be suspended from the motors, meaning both the cylinder wheels and the outer cylinder would need to be able to take a lot of strain from continous running. To solve this problem we chose sturdy motors, but in addition we replaced the motor axle with a sturdier mount (or hub) to connect to the cylinder wheels. Another problem we faced was spinning of the interior. If not properly secured, the interior of Cylindero would spin instead of the exterior (the same reason why a flying machine with one blade would not work). The motors needed leverage, something to push against. To solve this problem we suspended all the weight below the motors, however it does still remain a technical difficulty that is a product of its desgin. We will now demonstrate this vehicle's power in action...