Today Mackenzie and I worked on making new folds to try out while Riana worked on making a bracelet in fusion. We had trouble figuring out webbing but by lunch we had several new folds with webbing designed in rhino and Riana was printing her bracelet. After lunch Mackenzie and I started to laser cut our folds. Unfortunately, we had a great amount of trouble learning how to use the small laser cutter and after about an hour we only had one successful cut and one salvageable cut. After we had been at this for very long we decided to give up and start again tomorrow. It was not a very successful day. Also Rianas bracelet came out pretty good but a bit too large and the hole for the sensor isn't quite right. So we'll fix that tomorrow. Also our original fold is a bit to big which we will fix once we have successful cuts.