Today Sasha and I got right to work. We 3D printed a bigger button and put it together with springs and and nails. We had to drill through it a bit because some of the holes, didn’t go all the way through. We cut the wire in half but didn’t put it into the button yet. We printed out our design for the felt and realized that where the corners of the stars and diamonds met, there was just a gap so we made the stars smaller. We also added holes for the eyelets. Rosa and Emily suggested we transfer the hexagonal pattern to the arm pieces, so we worked on those. It was frustrating to move and copy all the eyelets and then trim so that it looked good. In the end, I think we found a good pattern. I hope that tomorrow we can actually put the dress together with the electronic part and see if it works.