today me, and vicky sautered some wires to make our led light up when we clicked the button. then we made a hole in the tile for the button, and put some springs in it. so that when you step on the tile it doesn't go all the way down it just pushes the light for it to come on.

this was on the floor when me, and vicky were cutting the cardboard to make tiles.

today me and vicky made a example of how our spatial sound tile looks. we are using clips as the hinges, and the wires, and batteries are to light the led so it can stay on.

you walk into a room and it's dark. you hear a sound, and  you have to figure out where that sound is coming from. the sound keeps going off from the same tile. if you step on the wrong tile it makes ascreaming noise or different scary sounds, and turns red. after you step on the wrong tile everything turns black. you start over then you hear the good noise again. then you keep going until you find the blue tile. you hear a noise again coming from the next tile. you step on the wrong tile, and it turns red, and makes a scary sound. you hear another sound then you accidently step on two tiles, and they both light up so now you're confused. there is a rail around all of the tiles so you won't step out of the area.  you keep doing all this until you find your way out the room.

youre in a room and its dark and you have to step on the right tile and it lights up. If you step on the wrong tiles it buzzes and turns red, then you have to start over.